Descaling The Machine - Jura 657 Original Bedienungsanleitung

6 Maintenance

Descaling the machine

WARNING
CAUTION
CAUTION
CAUTION
38
T Take out the old CLARIS plus filter cartridge and the exten-
sion.
T Fit the extension onto a new filter cartridge.
T Fit the filter cartridge into the water tank, pressing slightly,
and push the cartridge holder back so that it audibly snaps
into place.
T Place a receptacle (at least 500 ml) under the hot water
spout.
m T Press the hot water button.
FILTER IS RINSING, water flows out of the hot water spout.
E The water may be slightly discoloured. This is not harmful to
health and does not affect the taste.
Filter rinsing stops automatically after approx. 500 ml.
Your IMPRESSA is once more ready for operation.
The IMPRESSA builds up deposits of limescale over time and auto-
matically prompts you to descale it when necessary. The degree of
calcification depends on the degree of hardness of your water.
If the descaling agent comes into contact with the skin or eyes, this
can cause irritation.
Avoid contact with the skin or eyes.
T
If the descaling agent comes into contact with the skin or the
T
eyes, rinse thoroughly with clean water. Should you get any
descaling agent in your eye, see a doctor.
If the wrong descaling agent is used, the machine could be dam-
aged and/or traces of detergent could be left behind in the water.
Only use original JURA care products.
T
If the descaling operation is interrupted, there may be damage to
the machine.
Allow the descaling program to run to the end.
T
If the descaling agent comes into contact with sensitive surfaces,
damage cannot be ruled out.
Remove any splashes immediately with clean water.
T