Before Using The Machine For The First Time; Filling The Water Tank; Rinsing The Machine; Preparing Coffee/Espresso - Jura SUBITO Bedienungsanleitung

Bed.subito d/F/I/E/SP/NL 22.10.2001
For safety reasons, the appliance leaves our factory set to the
position for drawing off coffee (Fig. 4). In order to turn the
cover, the crank handle must be lifted to the stop position:
The crank handle is used to rotate the cover and to press the
coffee powder that has been put into the machine. It can only
be lowered in the "Brewing" position (Fig. 2). In order to lift
or lower the crank handle, the release lever must be pulled out
(Figs. 3 and 5).
The cover can only be rotated in a counter-clockwise direction
when the crank handle has been lifted. It has two stop posi-
tions: "Fill coffee" (Fig. 1) and "Brewing" (Fig. 2). These
positions are reached when the cover is heard to click into the
stop as it is rotated and cannot be turned back in a clockwise
direction.

5. Before using the machine for the first time

5.1 Filling the water tank

Please take the following steps when putting the machine into
operation for the first time, when the machine has been left
unused for a longish period of time (i.e. vacation) or if the
water tank is totally empty:
● Move the crank handle to the coffee withdrawal position
(Fig. 4).
● Fill the water tank with fresh tap water and insert the tank
carefully into the machine. Ensure that the tank clicks
correctly into position.
● Press the operating switch ( ).
● Place an appropriate cup under the pivoting nozzle and set
the selection switch to the water function (
● Turn on the operating switch and draw off one cup of water
( ).
Now your machine is filling with water.
38
17:39 Uhr Seite 38

5.2 Rinsing the machine

Please take the following steps when putting the machine into
operation for the first time or when the machine has been left
unused for a longish period of time (i.e. vacation):
● Move the crank handle to the coffee withdrawal position
● Fill the water tank with fresh tap water and insert the tank
● Plug the appliance into the mains and operate power switch
● Set the selector switch to the coffee position (
● When approximately two cups have been drawn off, turn

6. Preparing coffee/espresso

6.1 Filling the water tank
Fill the water tank with fresh tap water (no further than the
mark) and replace it in the machine. Ensure that it clicks
home correctly. Now switch on the power switch ( ). When
the heater warning lamp ( ) goes out, the machine is ready for
use.
). Important: Only use fresh tap water. Never fill the tank with
(Fig. 4).
carefully into the machine. Ensure that the tank clicks
correctly into position.
( ). When the heater warning lamp ( ) goes out, the
machine is ready for use.
an appropriate vessel under the coffee spout; now turn on
the operating switch ( ).
off the operating switch, lift up the crank handle and rotate
the cover back to its basic position i.e. the "Fill coffee"
position (Fig. 1).
milk, mineral water or any other liquid.
) and place