FRIATEC RPS Bedienungsanleitung Seite 24

EN
Note that for inflating the repair balloon, the air
hose on the pump is assembled on the outlet side
"Inflate" (see Fig. 19).
The correct positioning of the repair balloon and
the tight sealing of the repair balloon in the pipe
(see Fig. 20) is to check and if necessary to correct.
Close the shut-off valve (see Fig. 21).
If water continues to flow, the position of the repair balloon must be relocated,
if necessary the internal pressure of the repair balloon must be increased.
Check with the manometer that during pumping, air reaches into the repair
balloon.
NOTICE
Take care during pumping that the repair balloon will be filled with air slow and
evenly. Fast inflation can destroy the repair balloon.
Replace the repair balloon if it's damaged. Each repair balloon may only be
used once.
24
Deflate
Fig. 19
Fig. 20
Fig. 21
Inflate