Operating Your Appliance; Operation; Control With Levels; Grease Filter Alarm - Beko HCA92844BH Anleitung

4

Operating your appliance

4.1 Operation

• Use high suction power if excessive vapor is
formed in kitchen. It is recommended that hob
hood suction unit is turned on 5 minutes before
beginning cooking and is left in operation during
and for 15 minutes after cooking.

4.2 Control with levels

T1 T2
T1. On/Off key. If the appliance is OFF, turns on
the appliance. If the appliance is at any speed
level, turns it OFF .
T2. Operates the appliance in speed levels 1, 2
and 3.
Operates the appliance in speed level 1. LED 1
lights.
Operates the appliance in speed level 2. LED 2
lights.
Operates the appliance in speed level 3. LED
3 lights.
T3. Operates the appliance at speed level 4 for 5
minutes. While the appliance is in operation
in any level (1, 2, 3) if this key is pressed then
the current speed LED will become steady
and speed level 4 LED will flash. At the end of
5 minutes, speed level 4 LED will switch OFF
and the product will exit max. speed mode. If
speed level 4 key is pressed before 5 minutes
is over, the product exits max. speed mode.
T4. Lamp On/Off key. Briefly press this key to
turn ON/OFF the lamp. Press and hold for
more than 1 second to select one of the 5
brightness levels.
16 / 242 EN

4.3 Grease filter alarm

Flashing of LED 1 warns the user for cleaning the
metal filter. When this alarm is given, it is time to
clean the grease filter. Press and hold the ON/OFF
key for 3 seconds to reset the warning while the
product is in operation. LED 1 will stop flashing.

4.4 Charcoal filter alarm

The product is delivered with the charcoal filter
alarm deactivated. Press and hold keys 1 and 2 for
3 seconds to activate the charcoal filter cleaning
T3 T4
warning while the product is OFF. First LED 1 and
then LED 1 and 2 light up and indicate that the
warning is activated. Press and hold keys 1 and 2
for 3 seconds to deactivate the warning while the
product is OFF. First LED 1 and 2 then LED 1 light
up and indicate that the warning is deactivated.
Flashing of LED 2 warns the user for cleaning the
charcoal filter. Press and hold the ON/OFF key
for 3 seconds to reset the the warning while the
product is in operation.
C

4.5 Energy efficient usage:

• When operating the hood, adjust the speed
level according to the odour and vapour
intensity in order to prevent unnecessary
power consumption.
• Use low speeds in normal conditions (1-2), and
high speeds (3-4) when smell and vapors are
intensified.
• Lamps on the hood are intended for illuminating
the cooking zone. Using them to illuminate the
ambient/kitchen will result with unnecessary
power consumption and inadequate
illumination.
If both metal and charcoal filter
warnings are activated simulta-
neously, resetting should be per-
formed separately for each warn-
ing.
Hood / User Manual