Operation; User Interface; Instantaneous Dhw Cylinder Operation Following A Power; Failure - STIEBEL ELTRON SHD 30 S Bedienung Und Installation

operation

operation
4. Operation
4.1

user interface

4
3
2
1 ON/OFF indicator light for the booster heater
2 Push button for the booster heater
(only in dual-circuit operation)
3 Temperature selector
4 "SERVICE ANODE" indicator light
Possible damage
!
If the "SERVICE ANODE" indicator light illuminates,
please contact your heating contractor.
The temperature is infinitely adjustable.
• cold
E recommended energy saving position,
low scaling
85 °C maximum set temperature
Depending upon the system, the temperatures may vary from
the set value.
The ON/OFF indicator light illuminates while the water is heated
by the booster heater.
4.2 Instantaneous DHw cylinder operation
following a power failure
Following a longer power failure, you can switch the booster
heater on manually straight away by first turning the temperature
selector to the "cold" position and then up to 85 °C.
4.3

Dual-circuit operation with booster heater

You can switch on the booster heater by means of the push button.
A remote control can also be installed for this purpose. When the
set temperature has been reached, the booster heater switches
off and does not come on again.
18 |SHD S
5.

Cleaning, care and maintenance

Never use abrasive or corrosive cleaning agents. A damp cloth
»
is sufficient for cleaning the appliance.
Check the taps regularly. You can remove limescale deposits at
»
1
the tap outlets using commercially available descaling agents.
Regularly activate the safety valve to prevent it from becoming
»
blocked by limescale deposits.
Have the appliance's electrical safety and the safety assembly's
»
function regularly checked by a heating contractor.
The protective anode must be replaced by the heating contractor
»
as soon as the "SERVICE ANODE" indicator light illuminates (see
chapter "Maintenance / Replacing the protective anode").
6.

What to do if...

6.1

... the appliance develops faults

fault
The water does not
heat up.
The outlet flow rate
is low.
"SERVICE ANODE"
indicator light
illuminates.
If you cannot remedy the fault, notify your contractor. To facilitate
and speed your enquiry, please provide the serial number from
the type plate (no. 000000-0000-000000):
Cause » remedy
There is no power. Check the fuse/MCB
in your fuse box/
distribution panel.
The perlator in the tap or Clean and / or descale
shower head is scaled or the perlator or the
contaminated. shower head.
The protective anode Notify your local
must be replaced. contractor.
Nr.: 000000 - 0000 - 000000
www.Stiebel-eltron.CoM
Made in Germany