Specifications; Double Insulation - Makita 4131 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lever
1-2. Depth guide
2-1. Cutting line
3-1. Switch trigger
3-2. Lock-off button
4-1. Dust cover
4-2. Knob
5-1. Hex wrench
5-2. Shaft lock
6-1. Hex socket head bolt

SPECIFICATIONS

Max. cutting capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･

DOUBLE INSULATION

･
Pay attention! It may become too hot.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting in mild steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Explanation of general view
6-2. Outer flange
6-3. Carbide-tipped saw blade
6-4. Inner flange
7-1. Slot
7-2. Rib
8-1. Rip fence (Guide rule)
8-2. Screw
9-1. Carbide-tipped saw blade
9-2. Workpiece
10-1. Sight window
Model
Balde diameter
-1
)
Overall length
Net weight
Safety class
equipment
environmentally
END209-3
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode : cutting steel pipe
Vibration emission (a
and its
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
compatible
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENE022-1
WARNING:
ENF002-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
10-2. Workpiece
11-1. Retracting lever
12-1. Sight window
13-1. Dust cover
13-2. Knob
14-1. Limit mark
15-1. Screwdriver
15-2. Brush holder cap
4131
185 mm
63 mm
3,500
358 mm
5.1 kg
/II
) : 99 dB(A)
pA
) : 110 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s or less
h
2
ENG102-3
ENG241-1
vector sum)
ENG901-1