Clock Functions - JUNO JB097C9 Benutzerinformation

Tank empty indicator
The indicator shows that the tank is
empty and must be refilled.
For more information refer to "Steam
Cooking".
Tank Full indicator
The indicator shows that the oven is
prepared for steam cooking.
If you put too much water into
the tank, the safety outlet
moves the excess water to the
bottom of the oven.
Remove the water with a
sponge or cloth.
Emptying the water tank
CAUTION! Make sure that the
oven is cold before you start to
empty the water tank.
1. Prepare the draining pipe (C), included
in the package with the user manual.
Put the connector (B) onto one of the
ends of the draining pipe.
2. Put the second end of the draining
pipe (C) into a container. Put it at a
lower position than the outlet valve (A).

CLOCK FUNCTIONS

Clock functions table
Clock function
TIME OF DAY
DURATION
END
TIME DELAY
MINUTE MIND‐
ER
3. Open the oven door and put the
connector (B) into the outlet valve (A).
4. Push the connector again and again to
empty the water tank.
The water may remain inside after the
Tank Empty indicator
until the water flow from the water
outlet valve stops.
5. Remove the connector from the valve
when the water stops flowing.
Application
To set, change or check the time of day.
To set how long the appliance operates.
To set when the appliance deactivates.
To combine DURATION and END function.
To set countdown time. This function has no effect on the op‐
eration of the appliance. You can set the MINUTE MINDER at
any time, also when the appliance is off.
A
B
C
Do not use the drained water to
fill the water tank again.
9
is on. Wait