Replacing The Lamp; Troubleshooting - JUNO JB097C9 Benutzerinformation

forward and remove the door from its
seat.
4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
6. Pull the door trim to the front to
remove it.
7. Hold the door glass panel by its top
edge and carefully pull it out. Make
sure the glass slides out of the
supports completely.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
1
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
Do not clean the glass panels in the
dishwasher.
When the cleaning is completed, install
the glass panel and the oven door.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones
is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.

Replacing the lamp

WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
CAUTION! Always hold the
halogen lamp with a cloth to
prevent grease residue from
burning on the lamp.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
31
A