Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C
h
a
n
g
i
n
g
t
h
e
b
l
a
C
h
a
n
g
i
n
g
t
h
e
b
l
Remove the mains plug before changing the blades.
Risk of injury to the fingers and hands when carrying out
work on the blade unit. Wear protective gloves.
Reduced output
One edge of the knife has become blunt:
Turn knife so that you can use the other edge.
All knive edges have become blunt:
Replace with new set of knives (order-no. 382425).
Open the machine.
1. Open the machine by removing the
2. Fold down
the housing cover.
Turning or replacing the knives
1. The slot in the knife plate (18) must be aligned with the slot in
the counter knife (15). Insert a screwdriver through the slots to
fix the knife plate.
2. Remove the screws. Turn the knife or replace it.
3. To turn or replace the second knife remove the screwdriver
and turn the knife plate. Repeat then the steps 1 and 2.
16
d
e
s
a
d
e
s
locking screw.
M
a
i
n
t
e
n
a
n
c
e
a
n
d
M
a
i
n
t
e
n
a
n
c
e
a
n
d
•
Each time before starting maintenance work:
− Switch off the motor and pull out the mains plug.
− Wear protective gloves to prevent injury.
When the machine is stopped for purpose of maintenance,
storage or accessory replacement make sure that the energy
source is isolated and the mains plug is disconnected. Make
sure that all movable parts are stationary and the key (if
applicable) is removed. Allow the machine to cool down
before maintenance, adjustment etc.
The cutters will not come to a standstill immediately after
cut-off. Before starting any service work wait until all parts
are stationary.
When performing maintenance operations on the cutting tool
be aware that it can still move due to the start mechanism
even if the motor does not run by the cover interlocking.
Be sure to have removed any tools from the machine after
completion of service work.
•
Generally garden shredders require little maintenance. To
maintain their efficiency and a long life, observe the fol-
lowing:
− Keep vent slits clean and free from obstructions.
− Check the locking screws (tighten where necessary).
− Clean the device after shredding.
To clean your product only use a warm moist cloth and a soft
brush.
Never use cleaning agents or solvents. Otherwise the device
may be damaged irreversibly. Plastic parts may be corroded
by chemicals.
− Do not clean the machine with running water or high-pressure
cleaners.
After each operation treat bare metal parts with an environment-
compatible biodegradable spray oil to protect them against corro-
sion.
c
l
e
a
n
i
n
g
c
l
e
a
n
i
n
g
Werbung
Kapitel
Inhaltsverzeichnis
