Fagor ADVANCE+ APG-061 Bedienungs- Und Wartungsanleitung Seite 40

MANUAL FOR USE AND MAINTENANCE
ENGLISH
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
Description:
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
DESCRIPTION
CONSEQUENCE
DESCRIPTION
If the motor does not start within 10 seconds of a start request.
If a speed of 500 rpm is not exceeded within 20 seconds of a start
request.
The oven is completely disabled
E8: Needs water
The VDV is observed to have been running for 7 or more minutes and the
maximum level has not been reached.
It is only possible to operate in Convection mode
E9: Err. Drainage
The VAC is observed to have been running for 1 or more minutes and the
minimum level has not been reached.
It is only possible to operate in Convection mode
E10: CV Fault
If TG<93ºC, when CV is active, in 3 minutes, TG does not rise 3 or more
degrees.
I
t is only possible to operate in Convection mode
E11: CC Fault
The CC operates and in 12 minutes, the TC does not rise 3 or more
degrees.
The oven is completely disabled
E12: Temp. High
The controller NTC reaches 60ºC, but does not exceed 70ºC
The oven operates normally and the bell is not heard. This message is
displayed for 3 seconds every 30 seconds.
E13: VCC fault
VCC does not respond to the gas control and is at maximum speed.
The oven is completely disabled
E14: VCC fault
VCC does not respond to gas control and has stopped.
The oven is completely disabled
E15: VCC fault
VCC does not respond to the gas control and the speed is not stable.
The oven is completely disabled
E16: VCV fault
VCV does not respond to the gas control and is at maximum speed.
It is only possible to operate in Convection mode
E17: VCV fault
VCV does not respond to gas control and has stopped.
40
ADVANCE PLUS
(Only GAS ovens)
(Only GAS ovens)
(Only GAS ovens)
(Only GAS ovens)
(Only GAS ovens)