Noise And Vibration; Disposal Information; Declaration Of Conformity - Flex L 1710 FRA Handbuch

If a guard is recommended, prevent the

guard and wire brush from touching each
other. The diameter of plates and cup
brushes may increase due to contact
pressure and centrifugal forces.
Additional safety instructions
The mains voltage and the voltage

specifications on the rating plate
must correspond.
Do not press the spindle lock until

the grinding tool stops.

Noise and vibration

NOTE
Values for the A-weighted sound pressure
level and for the total vibration values can
be found in the "Technical specifications "
table.
The noise and vibration values have been
determined in accordance with EN 60745.
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this infor-
mation sheet has been measured in accor-
dance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories
or poorly maintained, the vibration emission
may differ. This may significantly increase the
exposure level over the total working period.
However if the tool is used for different
applications, with different accessories
or poorly maintained, the vibration emission
may differ. This may significantly decrease the
exposure level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
18
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).

Disposal information

WARNING!
Render redundant power tools unusable
by removing the power cord.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2012/19/EC on Waste Electrical and
Electronic Equipment and transposition
into national law used electric power tools
must be collected separately and recycled
in an environmentally friendly manner.
NOTE
Please ask your dealer about disposal
options!

-Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data"
conforms to the following standards
or normative documents:
EN 60745 in accordance with the
regulations of the directives
2004/108/EC (until 19.04.2016),
2014/30/EC (from 20.04.2016),
2006/42/EC, 2011/65/EC.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Eckhard Rühle
Manager Research &
Development (R & D)
11.05.2015
FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Angle grinder
Klaus Peter Weinper
Head of Quality
Department (QD)