Operating Instructions; Switch On And Off - Flex SBG 3908 Bedienungsanleitung

Metal band saw SBG3908
Damage to property!
– The mains voltage and the voltage
specifications on the rating plate (18)
must correspond.
– Do not use lubricants or coolants.

Operating instructions

Danger!
Before carrying out any work on the power
tool, always pull out the mains plug.
Before switching on the angle
grinder
Unpack the metal band saw and check that
no parts are missing or damaged.
Compare the mains voltage with the
specifications on the rating plate (2).
Installation
n Lift the machine onto the machine table
(8) or
n insert the pin (11) into the opening
on the swivel support (12) and lift the
machine on the saw frame (2).
Caution!
When selecting the installation location,
ensure that the installation surface is
adequately stable and that there is sufficient
light.
Note
The ergonomically optimum working height
is 90–95 cm.

Switch on and off

Switching on:
n Press the main switch "On" (16).
n Take hold of the handle (1) with your
right hand and press the switch.
The saw band starts running.
Switching off:
n Release the switch on the handle (1).
The saw band stops.
n Press the main switch "Off" (15).
Note
Following a power failure, the switched on
power tool does not restart.
Adjusting the cutting rate
n Set the required cutting rate with the
switch (17).
– I = 60 m/min
– II = 80 m/min
17