Flex L 1710 FRA Handbuch Seite 14

Angle grinder
L 1506 VR/LE 14–7 125 INOX only:
This electric power tool must be used

as a grinder, sander, cut-off grinder,
polisher and for work with wire brushes.
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool.
Failure to follow all instructions listed
below may result in electric shock,
fire and/or serious injury.
L 1710 FRA/L 3309 FR/L 3410 FR/
L 3410 VR only:
This electric power tool must be used

as a grinder, sander, cut-off grinder
and for work with wire brushes.
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow
all instructions listed below may result
in electric shock, fire and/or serious
injury.
This electric power tool is not suitable

for polishing. Operations for which
the power tool was not designed may
create a hazard and cause personal
injury.
Do not use accessories which are not

specifically designed and recommen-
ded by the tool manufacturer.
Just because the accessory can
be attached to your power tool,
it does not assure safe operation.
The rated speed of the accessory must

be at least equal to the maximum speed
marked on the power tool.
Accessories running faster than their
rated speed can break and fly apart.
The outside diameter and the thickness

of your accessory must be within the
capacity rating of your power tool.
Incorrectly measured insertion tools
cannot be adequately shielded
or controlled.
Sanding discs, sanding pads or other

accessories must fit exactly on the grin-
ding spindle of your electric power tool.
Insertion tools, which do not fit exactly on
the grinding spindle of the electric power
tool, rotate unevenly, vibrate violently
and may result in loss of control.
Do not use a damaged accessory.

Before use, always check insertion tools
for splinters and cracks, sanding pad
for cracks, wear and severe abrasion.
If power tool or accessory is dropped,
inspect for damage or install an un-
damaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from
the plane of the rotating accessory
and run the power tool at maximum
no-load speed for one minute.
Damaged accessories will normally
break apart during this test time.
Wear personal protective equipment.

Depending on application, use face
shield, safety goggles or safety glasses.
If appropriate, wear a dust mask, hearing
protection, protective gloves and/or
a special apron which protect you from
small sanding and material particles.
The eye protection must be capable
of stopping flying debris generated
by various operations. The dust mask
or respirator must be capable of filtrating
particles generated by your operation.
Prolonged exposure to high intensity
noise may cause hearing loss.
Keep bystanders a safe distance

away from work area.
Anyone entering the work area must
wear personal protective equipment.
Fragments of workpiece or of a broken
accessory may fly away and cause injury
beyond immediate area of operation.
Hold power tool by insulated gripping

surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the
power tool "live" and shock the operator.
Position the cord clear of the spinning

accessory.
If you lose control, the cord may be cut
or snagged and your hand or arm may
be pulled into the spinning accessory.
Never lay the power tool down until the

accessory has come to a complete stop.
15