Troubleshooting; Corrective Action; Scrapping And Disposal Of The Machine; Spare Parts - Bell LOGic Wartungs- Und Betriebsanleitung

7.2 - Troubleshooting

Problems that may arise when using the log splitter and recommended remedies are given in the table below. In the case of operations carried out
by unauthorised personnel, the guarantee will be immediately null and void and the manufacturer will be relieved of any responsibility for injury to
persons and animals and damage.
Problem
Log fails to split
Rod advances jerkily or with strong
vibrations
Oil leak from the rod or from other external
points

SCRAPPING AND DISPOSAL OF THE MACHINE

The machine must be scrapped in compliance with all safety regulations for the prevention of personal injury and damage to the environment and
animals.
All parts of the machine must be scrapped and disposed of in accordance with applicable legislation in the place of scrapping.
Dispose of hydraulic fluid and electric parts correctly. Do not dispose of these in the environment, as they are hazardous pollutants, and treat them
in accordance with applicable legislation.
Machines fitted with electrical parts must not be disposed of as general waste and must be separated for disposal as separately collected
fractions, deposited at authorised collection points.
The manufacturer is committed to waste recycling (WEEE) and is a member of specialised waste disposal consortiums.
Incorrect waste disposal is punishable by law.

SPARE PARTS

Replacement of spare parts and therefore extraordinary maintenance of the machine must be carried out by the retailer's specialised and
authorised personnel only. If any maintenance operations other than those expressly indicated in this handbook are carried out, the warranty will
be immediately null and void and manufacturer shall be relieved of all and any responsibility with regard to accidents involving persons, animals or
things. Always order spare parts form your regular retailer remembering to indicate the machine model, the purchase date and the serial number.
18
Probable cause
Incorrect positioning of the log
Log exceeds permitted dimensions or the wood
is too hard for the capacity of the machine.
Wedge do not cut
Oil leack
Hydraulicpressure too low
Air in the circuit
Leakage from the tank
Seals worn

Corrective action

Position correctly the log
Try to cut a small part or use other means to
reduce the size of the log
Sharped the wedge, check for burrs or nicks,
file if necessary
Locate the leack using a piece of card or wood.
Contact your dealer
Contact your dealer
Check oil level.Top up if necessary
If problem remain contact your dealer
Check that the bleed screw has been tightened
before moving the machine (Fig. 5, page 3).
Contact your dealer
D22000400 v.3 UPD 190510
ENGLISH