Specifications - Makita 5704R Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lever
2-1. Clamping screw
3-1. Base
3-2. Cutting line
4-1. Setting protuberances
4-2. Hex socket head bolt (For adjusting
riving knife)

SPECIFICATIONS

Max. cutting depth
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
Explanation of general view
4-3. Cutting depth
5-1. Switch trigger
5-2. Lock-off button
6-1. Hex wrench
6-2. Shaft lock
7-1. Hex socket head bolt
7-2. Outer flange
Model
Blade diameter
at 90°
at 45°
-1
)
Overall length
Net weight
Safety class
) : 85 dB(A)
pA
) : 96 dB(A)
WA
2
) : 2.5 m/s or less
h,W
2
ENE028-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENF002-2
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG905-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
ENG900-1
Designation of Machine:
Circular Saw
Model No./ Type: 5704R
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
ENG901-1
standards or standardised documents:
EN60745
3
7-3. Saw blade
7-4. Inner flange
8-1. Vacuum cleaner
10-1. Rip fence (Guide rule)
11-1. Limit mark
12-1. Brush holder cap
12-2. Screwdriver
5704R
190 mm
66 mm
46 mm
4,900
345 mm
4.9 kg
/II
Corporation as the
ENH101-16
responsible