Cleaning The Clipper; Cleaning With The Brush - Panasonic ER-GC71 Bedienungsanleitung

Cleaning the clipper

• Clean the clipper and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the clipper is turned off.
1. Remove the clipper from the AC adaptor.
To remove light dirt
2. Remove the comb
attachment and turn the
clipper on.
3. Run water down the water
inlet at the front of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the clipper off.
• Rinse with water and
shake up and down
several times to remove
the water.
14
To remove heavy dirt
2. Remove the comb
attachment and blade.
3. Clean the clipper, the blade
and the comb attachments
with running water.
• Rinse with water and
shake up and down
several times to remove
the water.
4. Wipe off the water with a towel and
let it dry naturally.
• It will dry faster with the blade
removed.
5. Apply the oil to the blade after drying.
(See page 15.)

Cleaning with the brush

• Remove the blade. (See page 15.)
1. Brush off any hair trimmings from the
main body and from around the blade.
2. Brush off the hairs from the blade edge.
3. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever (a) to raise the moving
blade.
4. Apply the oil to the blade. (See page 15.)
