Using The Hair Clipper - Panasonic ER1512 Bedienungsanleitung

About the LED display
After charging is
While charging
completed
HIGH
MID
LOW
glows.
blinks once
•
"HIGH", "MID" or
every second.
"LOW" blinks.
While using
"HIGH" blinks ‑ The battery capacity is enough.
HIGH
"MID" blinks ‑ The battery capacity is approx.
MID
LOW
"LOW" blinks ‑ The battery capacity is approx.
•
Charge the clipper when "LOW" starts to blink.
Charging without the charging stand

1. Slide the 0·CHARGE/1 switch to
"0·CHARGE", and insert the
appliance plug into the clipper.
2. Plug in the AC adaptor into an
outlet.
10 minutes after
charging is
completed
HIGH HIGH
MID MID
LOW LOW
blinks once
every 2 seconds.
•
"HIGH/MID/LOW"
go out.
60% or less.
10% or less.
AC operation

If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it even if the battery
capacity is low.
•
If the clipper does not operate, charge the clipper for
approximately 1 minute.
•
Be careful not to discharge the battery completely with the power
left turned on. It results in shortening the battery life.
Cut
Using the hair clipper
We recommend using the clipper in an ambient
temperature range of 0 ‑ 5 °C. If used outside this
range, the appliance may stop operating.
Turn the dial clockwise or counterclockwise to adjust
the moving blade back and forth to get the desired
height. Adjustable in 5 stages from 0.8 mm to 2.0 mm
in 0. mm steps without attachments.
Actual hair length will be a little longer than the set
length.
Using the comb attachments

1. Select the trimming heights indicated on
the insides and sides of the attachments.
2 Set the dial to "0.8" and then mount the
attachment to the clipper as illustrated.
0.8
5