Blade Life; Battery Life; Removing The Built-In Rechargeable Battery - Panasonic ER-GC71 Bedienungsanleitung

Problem
The clipper cannot be
charged.
Clipper can be used for
only about 10 minutes
even after charging.

Blade life

Blade life varies according to the frequency and period of use of
the clipper.
For example, the blade life is approximately 2 years when using the
clipper for 20 minutes twice a month. Replace the blades if cutting
efficiency reduces substantially despite proper maintenance.

Battery life

Battery life will vary according to the frequency and length of use.
If the battery is charged once a month, the service life will be
approximately 3 years.
If the operating time is significantly shorter even after a full charge,
the battery has reached the end of its life.
16
Action
Push the appliance plug into the
main body all the way and make
sure the charge indicator lamp
( ) glows.
Charge within the recommended
charging temperature of 0 °C to
35 °C.
Have the battery replaced by an
authorized service centre.

Removing the built-in rechargeable battery

Remove the built-in rechargeable battery before disposing of
the clipper.
Please make sure that the battery is disposed of at an officially
designated location if there is one.
This figure must only be used when disposing of the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it will no longer be waterproof, which may cause it to malfunction.
• Remove the clipper from the AC adaptor.
• Slide the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps 1 to > and lift the battery, and then remove it.
• Take care not to short circuit the positive and negative terminals
of the removed battery, and insulate the terminals by applying
tape to them.













