7
Private exchanges/T-NET
You can use the "R" signal button
exchanges and when using DEUTSCHE TELEKOM's T-Net functions.
7.1
"R" Button on private exchanges
If you have connected your telephone to a private exchange, you can use
all the facilities such as call transfer, automatic recall, etc. The "R" signal
button gives you access to these facilities. The FLASH time "100ms" will
be required on a private exchange (Adjustment, see 8.4).You can find out
from the dealer from whom the equipment was purchased whether your
telephone will work on your private exchange without any problems.
7.2
"R" Button and the DEUTSCHE TELEKOM T-Net
Your telephone supports the most important DEUTSCHE TELEKOM
added value functions (e.g. brokering, call waiting, three-way conference,
etc.). The T-Net works using the "FLASH 300ms" setting. (Adjustment, see
8.4).Please contact DEUTSCHE TELEKOM to gain access to T-Net
functions.
7.3
Inserting an automatic pause
With some private exchanges, it is necessary to dial a certain number (e.g.
"9" or "0") in order, after a short pause, to obtain a dialling tone for an
outside line on the extension.
An automatic dialling pause of ca. 3 seconds can be stored in the
phonebook along with the number. When entering the number, hold the
button pressed at the required point until the P indicator appears in the
display. Then enter the remaining digits of the phone number and save the
number in the usual way.
- Private exchanges/T-NET -
on your telephone on private
43