Programming Standard Settings - AUDIOLINE TEL4clip Bedienungsanleitung

2.7

PROGRAMMING STANDARD SETTINGS

Telephone numbers are always shown in the display with
the local dialling code or, in the case of international calls,
also with the appropriate country code. If these numbers
are dialled directly from the caller list, the dialling code can
of course be omitted with local calls. Therefore, you should
enter your local dialling code and the country code for
Germany (0049). Moreover, you can also enter the date
and time at this point.
1. Lift the receiver.
2. Press and hold the
seconds.
3. The display will show "-----, local dialling code". Now
enter your local dialling code with a maximum of 5
digits.
4. Press the
until you see the message "country code" in the
display. If a 5 digit local dialling code is entered the
display jumps directly to the next entry "country code".
5. Now enter the country code 0049 for Germany.
6. Press the
until you see the message "TIME? DATE?" in the
display. Now enter the current hour between 00 and
23 using the
the
7. Now enter the current minute between 1 and 59 using
the
button.
8. Now enter the current day between 1 and 31 using the
and
button.
9. Now enter the current month between 1 and 12 using
the
button.
Important information!
If you ever have to change the standard settings, start
programming as described under item 1. You can now
move the flashing cursor to any number using the
button and make a change using the
You can automatically go from the local dialling code to the
country code and to the time entry by repeatedly pressing
the button. To shorten a local or country dialling
code, go to after the end of the numbers you have entered
(cursor flashes) and then use the
enter the minus sign "-".
button as many times as necessary
button as many times as necessary
and
button.
and buttons and confirm with the
buttons and confirm with the
and buttons and confirm with the
and
buttons and confirm with
and
17
buttons for 4
and buttons.
buttons to