The Wireless Tab - Wireless Mac Filter; Figure 6-20: Wireless Tab - Wireless Security (Radius); Figure 6-21: Wireless Tab - Wireless Security (Wep) - Linksys WRT54GS Bedienungsanleitung

Wireless-G Broadband Router with SpeedBooster

The Wireless Tab - Wireless MAC Filter

Wireless access can be filtered by using the MAC addresses of the wireless devices transmitting within your
network's radius.
Wireless MAC Filter. To filter wireless users by MAC Address, either permitting or blocking access, click Enable.
If you do not wish to filter users by MAC Address, select Disable.
Prevent. Clicking this button will block wireless access by MAC Address.
Permit Only. Clicking this button will allow wireless access by MAC Address.
Edit MAC Address Filter List. Clicking this button will open the MAC Address Filter List. On this screen, you can
list users, by MAC Address, to whom you wish to provide or block access. For easy reference, click the Wireless
Client MAC List button to display a list of network users by MAC Address.
Change these settings as described here and click the Save Settings button to apply your changes or Cancel
Changes to cancel your changes.
Chapter 6: Configuring the Wireless-G Broadband Router
The Wireless Tab - Wireless MAC Filter
IMPORTANT: If you are using WEP
encryption, always remember that each
device in your wireless network MUST use
the same WEP encryption method and
encryption key, or else your wireless network

Figure 6-20: Wireless Tab - Wireless Security (RADIUS)

Figure 6-21: Wireless Tab - Wireless Security (WEP)

45