Ensure that there is no possibility of
■
ignition of explosive or flammable
substances, such as petrol or solvents,
while using charger!
Ensure that there is adequate venti-
■
lation during charging .
DANGER OF CHEMICAL
BURNS!
Wear protective glasses! Wear
■
protective gloves! If eyes or skin has
come into contact with battery acid,
rinse the affected body region off
with a large amount of clean water
and consult a doctor straight away!
Avoid causing a short circuit when
■
connecting the charger to the bat-
tery . Connect the negative pole
connector cable only to the nega-
tive battery or to the body work .
Connect the positive pole connector
cable only to the plus pole of the
battery!
Do not place the charger close to fire,
■
heat or to places with long-term expo-
sure to temperatures over 50 °C!
Ensure that no fuel lines,electric
■
cables, hydraulic or water pipes
are damaged by the screws during
assembly of the charger!
Do not cover the charger with any
■
objects!
Protect the electrical contact sur-
■
faces of the battery from short
circuiting!
■
14
│
GB │ IE
Only use the charger for charging
■
and for charge retention of 6 V /
12 V lead batteries .
Do not charge frozen batteries .
Operation
Before use
♦
Before connecting the charger, the operating
instructions must be observed .
♦
Furthermore, the instructions of the vehicle man-
ufacturer regarding a permanently connected
vehicle battery must be observed . Secure the
vehicle, switch off the ignition .
♦
Clean the battery poles . Take care that while doing
so, your eyes do not come into contact with the dirt .
♦
Ensure sufficient ventilation .
Connecting
NOTES
►
There are two options for connecting the charger .
Connect the negative terminal connecting cable
(black) either directly to the negative terminal of
the battery or to the bodywork . Please also bear
in mind the vehicle manufacturer's instructions .
♦
Before starting the charging or trickle charging
procedure on a permanently installed battery in
a vehicle, first disconnect the negative terminal
connecting cable (black) of the vehicle from the
negative terminal of the battery . The negative
terminal of the battery is usually connected to
the vehicle's coachwork .
♦
Connect the positive pole clamp (red)
charger to the positive pole of the battery .
♦
Connect the negative pole clamp (black)
negative pole of the battery or to the bodywork .
♦
Connect the mains cable
the mains socket .
♦
The battery voltage display
rent battery voltage .
♦
Should the connection of the clamps be swapped,
the LED „reverse connection"
of the
to the
of the charger to
shows the cur-
lights up .
ULGD 3.8 B1