Oxy-Gen Plus Control Unit; Metering Pumps - ECOLAB Oxy-Gen PLUS Bedienungsanleitung

PLUS
5.1.1 Oxy-Gen
Fig. 5.2
5.1.2

Metering pumps

Fig. 5.3
The in-take side connections for the metering pumps are connected to each of the supply
containers via a tube and suction pipes.
In order to avoid confusing the supply containers, ensure that the substances are only
drawn by the metering pumps, via a suction tube and pipe, from a container which has
WARNING
identical markings to those shown on the metering pump! Otherwise, there is a risk of
uncontrolled release of chlorine dioxide concentrate.
For details about the control and operation of the metering pumps, refer to the Operating
Instructions enclosed with the unit! (Metering pump EMP KKS E60
NOTE
or metering pump EMP II E60
Art. No. 417101253)
417101630_OxyGen Plus.doc
control unit
Oxy-Gen
PLUS
The Oxy-Gen
is located on the right-hand side of the unit.
All the requisite actions are controlled via a
programmable logic controller and active via an
operator panel
(Fig. 5.11, Pos. 2) with a plain text display and
control buttons.
You can find a precise description of the control
unit in section 8.
There are separate EMP E60
(Fig. 5.1, Pos.
PLUS
Gen production unit for metering the
P3-oxodes / P3-oxocid and P3-oxonet.
The metering pump connections on the
pressure side are connected to the oval
gear meter (Fig. 5.1, Pos.
recording the flow rate, and are fed into the
reactor (Fig.. 5.1, Pos. 6).
PLUS
Art. No. 417101438, as well as software manual EMP E60
- 71 -
PLUS
control unit (Fig. 5.11, Pos. 9)
PLUS
pumps
2 & 11) mounted on the
4 & 10) for
PLUS
, Art. No. 417101442
Oxy-
1-04/09