Replacing The Electric Actuator - Invacare Roze Gebrauchsanweisung

8.7 Replacing the Electric Actuator

A Electric Actuator
B Actuator Lead Routing
Hole
C Lift Arm Actuator
Mounting Bracket
D Rubber Caps
1164940-D
H Bearing
I Nylon Washer
J Actuator Cap
K Bushing
E Nut
F Screw
G Washer
1. Unplug the electric actuator from the control box on the mast
assembly. Thread the actuator lead through the actuator lead
routing hole in the mast assembly.
2. Remove the hardware that secures the top of the electric
actuator to the lift arm actuator mounting bracket.
a. Remove the rubber caps from the nut and screw that attach
the electric actuator to the lift arm actuator mounting
bracket.
b. Remove the screw, washer, bearing, nylon washer, actuator
cap, bushing, nylon washer, bearing, washer, flat washer and
nut.
The actuator cap will become loose when the attaching
hardware is removed. Inspect the actuator cap for
damage. Replace the actuator cap if damage is found.
3. Remove the hardware that secures the bottom of the electric
actuator to the mast assembly actuator mounting bracket.
a. Remove the rubber caps from the nut and screw that
attach the electric actuator to the mast assembly actuator
mounting bracket.
b. Remove the screw, washer, bearing, nylon washer, bushing,
nylon washer, bearing, washer, flat washer, and nut.
4. To replace the electric actuator, reverse STEPS 1-3.
Maintenance
L Flat Washer
M Mast Assembly Actuator
Mounting Bracket
41