Dmx512 Control; Operation; Operating Buttons - EuroLite LED KLS Laser Bar PRO FX Light Set Bedienungsanleitung

DMX512 control

A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2 Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:

OPERATION

The built-in control panel of the unit features four operating buttons and a display which shows all operation
statuses. After connecting the unit to the mains it requires a short initialization process and is then ready for
operation. The display shortly indicates the firmware version followed by the last operating mode. The light
set may be controlled via IR remote control, foot switch or a DMX controller. The operating modes can be
selected by means of the display and the control buttons.

Operating buttons

MENU
ENTER
UP
DOWN
Selects the operating mode or returns to the initial screen.
Activates a value to be modified or saves a value when modifying.
Selects the next menu item or increases values when modifying.
Selects the previous menu item or decreases values when modifying.
28/40 00121017, Version 1.0