Mögliche Rührer-Einstellungen:
•
OFF
Automatische Rührersteuerung ausgeschaltet
•
Int
Intervallsteuerung für Messungen und
Kalibrierungen mit Driftkontrolle AR
¦ Der Rührer startet mit dem Auslösen der
Messung (RUN):
Anzeige für Driftkontrolle AR blinkt.
¦ 10 s Rühren (5 s bei σ OFF).
¦ Rührer stoppt, Messung mit Driftkontrolle läuft
ohne Rühren bis zum Erreichen eines stabilen
Meßwerts.
•
Cont Kontinuierliches Rühren während der
Messung mit und ohne Driftkontrolle AR und
während der Kalibrierung. Der Rührer stoppt
nur
¦ bei statischer AR-Anzeige
(Erreichen eines stabilen Meßwerts, Aufruf
bzw. Abbruch der pH-Messung mit
Driftkontrolle)
¦ beim Auslesen des Speichers (RCL)
¦ zwischen den Einstellphasen.
Einstellen:
Int
Intervallbetrieb des Rührers.
Cont
Kontinuierlicher Betrieb des Rührers.
Bestätigen mit RUN/ENTER:
Automatische Rührersteuerung eingeschaltet.
Betriebsart "pH-Messen" mit
angeschlossenem Rührer und eingeschalteter
Rührersteuerung (z.B. kontinuierlicher
Betrieb):
Das Rührersymbol leuchtet, solange der
Rührerausgang mit Strom versorgt wird.
(Wenn ein Rührer angeschlossen ist, ist
dieser in Betrieb).
64
Konfigurieren
Configuration
Possible stirrer settings:
•
OFF
Automatic stirrer control switched off
•
Int
Interval control for measurements and
calibrations with drift control AR
¦ The stirrer starts with the start of the
measurement (RUN):
Display for drift control AR is flashing.
¦ 10 s stirring (5 s at σ OFF).
¦ Stirrer stops, measurement with drift control
runs without stirring until a stable measured
value is reached.
•
Cont
Continuous stirring during measurement
with and without drift control AR and
during calibration. The stirrer only stops
¦
with static AR indication
(a stable value is measured,
measurement with drift control is called up or
cancelled)
¦
during readout of memory (RCL)
¦
between the adjustment phases
Set:
Int
Continuous operation of the stirrer.
Cont
Interval operation of the stirrer.
Confirm with RUN/ENTER:
Automatic stirrer control switched on.
Operation mode "pH measurement" with
connected stirrer and switched on stirrer
control
(e. g. continuous operation):
The stirrer symbol is lit when the stirrer output
is supplied with current. (If a stirrer is
connected, it is working.)
BA11101/05.00/Pla/pH540GLP-4