Herunterladen Inhalt Inhalt Diese Seite drucken

Environmental Protection; Symbols On The Machine; General Notes On Safety; Proper Use - Kärcher HD 6/16-4 ST-H Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Please read and comply with
these instructions prior to the
initial operation of your appliance. Retain
these operating instructions for future refer-
ence or for subsequent possessors.
- Before first start-up it is definitely neces-
sary to read the safety indications Nr.
5.956-309!
- In case of transport damage inform ven-
dor immediately
Contents

Environmental protection

The packaging material can be
recycled. Please do not throw
the packaging material into
household waste; please send
it for recycling.
Old appliances contain valua-
ble materials that can be recy-
cled; these should be sent for
recycling.. Batteries, oil, and
similar substances must not
enter the environment. Please
dispose of your old appliances
using appropriate collection
systems.
Please do not release engine oil, fuel oil,
diesel and petrol into the environment
Protect the ground and dispose of used
oil in an environmentally-clean manner.
Kärcher detergents are easy-to-dispose.
This means that the functioning of an oil
separator is not hampered. Please find a
list of recommended detergents in the
chapter "Accessories".

Symbols on the machine

High-pressure jets can be
dangerous if improperly
used. The jet must not be di-
rected at persons, animals,
live electrical equipment or
at the appliance itself.

General notes on safety

Please follow the national rules and reg-
19
ulations of the respective country.
19
Please follow the safety instructions
which are attached to the used deter-
19
gents (normally on the packing label).
19
For operating this unit in Germany, the
20
"Guidelines for Fluid Sprays" published
21
by the Hauptverband der gewerblichen
22
Berufsgenossenschaft (Association of
22
Trade and Vocational Co-operatives) is
applicable (the same can be obtained
23
from Carl Heymanns Verlag, Köln,
23
www.heymanns.com).
23
The accident prevention regulation
25
(BGR 500) "Work with liquid rays" is val-
27
id. High pressure spraying units must be
29
checked every 12 months in accord-
ance with these guidelines by an expert
30
and the result of this check must be writ-
33
ten down.
34
- The device may only be installed by a
34
specialized company according to the
national regulations.
- All national laws and regulations about
installation of electrical appliances must
also be followed.
- The appliance may only be used by per-
sons who have been instructed in han-
dling the appliance or have proven
qualification and expertise in operating
the appliance or have been explicitly as-
signed the task of handling the appli-
ance.
- The appliance must not be operated by
children, young persons or persons who
have not been instructed accordingly.
Symbols in the operating instruc-
tions
Danger
indicates an immediate threat of danger.
Failure to observe the instruction may result
in death or serious injuries.
Warning
indicates a possibly dangerous situation.
Failure to observe the instruction may result
in light injuries or damage to property.
Note
indicates useful tips and important informa-
tion.
Work-stations
The unit is turned on and off only at the
pump unit. Depending on the plant installa-
tion, the work-stations are located at the ac-
cessories (spraying units) connected to the
feeder points.
Personal safety gear
Wear ear plugs to protect
your ears against hearing
loss while cleaning parts
that produce high sound
levels.
- Wear protective clothing and safety
goggles to protect against back spray
containing water or dirt.

Proper use

- This equipment produces water under
high pressure downstream to high pres-
sure cleaning devices. If required the
detergent is drawn in and added to the
water.
- The high pressure module is perma-
nently installed in a dry, frost-free room.
The temperature at the installation site
should not exceed 40 °C. The high
pressure water is distributed through a
fixed network of pipes.
- The high pressure model must be in-
stalled at a wall in such a way that the
rear opening is sealed by the wall.
Danger
Risk of injury! Follow the respective safety
regulations when operating at gas stations
or other dangerous areas.
Please do not let mineral oil contaminat-
ed waste water reach soil, water or the
sewage system. Perform engine cleaning
and bottom cleaning therefore only on
specified places with an oil trap.
19
English

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Hd 9/16-4 st-hHd 13/12-4 st-h

Inhaltsverzeichnis