Silvercrest SAB 160 B2 Bedienungsanleitung Seite 129

■ To avoid malfunctions, the installation angle should be less than 30°.
■ Do not install the device where it is subjected to high temperatures (i.e. direct
sunlight or heating vents), heavy contamination or strong vibrations.
■ Should modifi cations to the vehicle be necessary, contact your vehicle dealer
or specialist workshop.
Installing the device into the ISO bay
♦ Pull the installation bracket
housing. Use the supplied key
♦ Place the installation bracket into the ISO mounting bay.
♦ Bend the tabs on the installation bracket with a screwdriver so that the
bracket is fi xed fi rmly into the mounting bay (see diagram).
♦ Check to ensure the bracket is securely fi xed.
♦ Connect the ISO socket block of the device to the two ISO plugs on your
vehicle.
♦ Connect the cable from the vehicle aerial to the aerial socket
device. Any vehicle-specifi c ISO adapters you may require can be sourced
from a specialist workshop, a local dealer or a general store's technical
department.
♦ Feed the microphone unit cable into the mounting duct and connect it to the
microphone unit socket
phone unit can be secured in the vehicle interior later, see also the section
"Using the microphone".
♦ If required, connect the audio cinch cable of an external amplifi er to the
LINE OUT socket
♦ If required, connect the audio cinch cable of an external subwoofer to the
orange SUB-W cinch socket
♦ Protect your device against theft with additional measures as required.
Attach the securing screw with the anchoring plate
material to the engine fi rewall of the vehicle.
SAB 160 B2
and the bezel frame
39
(see also chapter "Removing the device").
40
25 . Run the cable in such a way that the micro-
on the device.
31
on the device.
30
from the device's
38
on the
32
and the securing
41
GB
125