Silvercrest SAB 160 B2 Bedienungsanleitung Seite 151

Fault
The CD jumps
Failure with
burnt CDs
The radio and/
or automatic
station store
function are/is
not working
The station
memory is not
working
The device on
the USB port
7
is not working
The card reader
cannot read the
card
The Bluetooth
®
connection is not
working
NOTE
► If you are unable to resolve the problem by applying any of the aforemen-
tioned methods, please contact the Customer Service department.
SAB 160 B2
Possible cause
The mounting angle exceeds
30°.
The CD is very dirty or
defective.
The aerial cable is not
connected correctly.
The station signals are too
weak.
Connector 4 in ISO Block A
(permanent plus) is not con-
nected correctly.
The USB port is intended for
devices that work in accord-
ance with the USB standard.
Not all devices available on
the marketplace conform to
this standard. It is possible
that a device that does not
comply with the USB stand-
ard is connected.
The card may be defective,
dirty or not properly inserted.
The mobile telephone does
not support Bluetooth ®
transfer.
The mobile phone is not
paired with the device.
Remedy
Correct the mounting angle.
Clean the CD or insert a diff erent CD.
Check the burnt CD in another play-
back device.
Check the aerial cable for correct
connection.
Set the station manually.
Check the cable connections. Please
refer to the chapter "Installation".
Connect a device that works in accord-
ance with the USB standard. Check that
the data medium is formatted with the
FAT32 fi le system.
Check the card. Slide it in with the let-
tered side pointing upwards. Check that
the data medium is formatted with the
FAT32 fi le system.
Reconnect the mobile phone and the
device. Please refer to the operating
instructions of your mobile phone.
GB
147