Troubleshooting - Gardena Easycontrol Betriebsanleitung

1881-20.960.02_12.11.2013_GARDENA.QXP 12.11.2013 07:45 Seite 113

8. Troubleshooting

Fault
No display appears
Manual watering is not
possible using the
Man. button
Watering program is not
being undertaken
(no watering)
Possible Cause
Battery inserted incorrectly.
Flat battery.
Temperature on the display
is higher than 60 °C.
Battery flat ( is continuously
displayed).
Tap turned off.
Controller is not connected.
Program entry / modification
during or just before the
start pulse.
Valve was opened manually
previously.
Tap turned off.
Soil moisture or rain sensor
registers damp.
Remedy
v Check polarity markings
match (+ / –).
v Insert new (alkaline) battery.
Display appears after
temperature has dropped.
v Insert new (alkaline) battery.
v Turn tap on.
v Mount controller on housing.
v Make program entry /
modification outside the
programmed start times.
v Avoid possible program
overlaps.
v Turn tap on.
v If dry, check setting / location
of soil moisture / rain sensor.
113