Putting Your Water Computer Into Operation - Gardena Easycontrol Betriebsanleitung

1881-20.960.02_12.11.2013_GARDENA.QXP 12.11.2013 07:45 Seite 104
24h 2nd 3rd 7th Off
0 +2h +6h +12h

4. Putting Your Water Computer into Operation

Insert battery:
104
0
Start time delay ( flashes when in input mode).
1x 2x 3x
Displays the remaining time until the program start.
+18h +24h
0
The Water Computer must only be operated with a 9 V alkali-
manganese (alkaline) battery type IEC 6LR61.
1. Remove controller
housing of the Water Computer.
2. Insert battery in the battery
compartment
correct polarity
The display shows all LCD
A
symbols for 2 seconds and
then the
duration flashes
(see 5. Programming).
3. Install controller
housing again.
A
from the
B
. Observe
z
.
P
symbol for watering
A
on the
B z
P