Operation - Klarstein Heatbox Handbuch

OPERATION

Preparation
Place the heater on a firm, level surface and plug into a grounded 220 V / 50 Hz
power outlet. and turn on the power switch in the rear of the unit. Only operate heater
in upright position with caster wheels attached. Insert 2 AAA batteries into the remote
control before using (Batteries Not Included)
battery compartment
Start and Select Working Mode
1
2
3
Batteries
Turn the heater on by pressing the ON/OFF button on the control
panel or by pressing the Power button on the supplied remote
control. Once power is off, heating element will stop working at
first. Fan will prolong working for 3 min to emit plenty of heat
inside. This mark will indicate running during the 3 min.
Select a heat Mode. Press the MODE button to toggle between
the three heat modes
High Mode uses 1500 W; Low Mode uses 750 W. ECO mode
is an Economic Energy Saving Function. When ECO mode is
chosen, the heater will manage itself from less to more heating
power (watts) in an attempt to maintain a constant warm
68°F (20°C).
EN
21