Setting The Desired Temperature - Klarstein Heatbox Handbuch

EN
22

Setting the desired Temperature

1
2
3
4
Setting the Power Off Timer
Note: The Power-Off-Timer Function will allow for the heater to power OFF after
a certain set time, and can only be set while the heater's display is in the "On"
position.
1
2
3
Adjust the desired temperature by pressing the
Up/Down arrows on the control panel or remote
control.
Desired temperature options vary from 59°F to
86°F or from 15°C to 30°C. Once you have
chosen the desired temperature, the heater will
remain on until the room temperature increases
to the temperature on the digital display. The
heater will cycle on and off to maintain the
desired room temperature.
Press °C/°F button to change the display
temperature between Fahrenheit and Celsius.
The Fahrenheit indicator LED will light , when
the temperature is displayed in Fahrenheit. The
Celsius LED will light, when the temperature is
displayed in Celsius.
Turn the heater to the "On" position .Press the
Timer button on the heater's control panel or the
remote.
The digital display changes from the
"temperature" to the "hours" option for the timer.
Continue to press the timer button to change
the number of hours you would like the heater
to run before powering itself off .The hour
options for the timer are from 0 to 12 hrs. (in 1 hr
increments).
The selected hour increments will flash for a
few seconds, then revert back to the set desired
temperature .The Timer indicator light will remain
lit as long as the Timer is set. The heater will
power OFF when the internal heater clock counts
down the hour increments you set.