Operation - Klarstein THERMAXX 2500 Bedienungsanleitung

EN

OPERATION

Work/Standby: Plug in the mains plug, the buzzer will "beep" for a long time, press
the standby key (On/Standby) to enter the high-grade heating working state, and
then press the standby key to enter the standby state.
Gear selection: For work status, press "MODE" key to select one of the work modes
such as high gear, medium gear, low gear and energy saving gear.
Temperature setting: Under the working status, press and hold the
key or key to
set the temperature. Press and hold these keys to quickly set the temperature. After setting
the temperature, have non-operation for 5 seconds, exit the temperature setting screen.
After the initial use or memory clear, the heater runs according to the factory settings.
The default setting temperature is 35 °C and the gear position is high-end.
Scheduled work: Tap the timer key in standby mode to enter the scheduled work
setting screen. Press the key or key to set the scheduled time. Press the key or
key for a long time to quickly set the scheduled time. When the scheduled time is
reached, the heater enters operating mode. The buzzer will ring with a long beep.
Scheduling standby: Under the working status, press the timer key
, to enter the
scheduling standby setting screen. Press the key or key to set the scheduling time.
Press the key or key for a long time to quickly set the scheduling time. When the
scheduled time is reached, the heater enters standby mode.
The scope of scheduling is for 0~24 hours. Press the key or key each time to
increase or decrease 1 hour. When the set value is "0 H", press the key or key to
set the time for "24 H". When the set value is "24 H", press the key, and the setting
time is "0 H". When the set value is "0 H", the scheduling is cancelled. When the set
value is not "0 H", the scheduling is started.
Set the appointment time, press the timer key or "MODE" key, or without operation
for 5 seconds, exit scheduling mode.
Cancel timer: If the scheduling time is set, press the standby key
to enter the standby
state and cancel the scheduling.
After the scheduling is started, press the scheduling key to check the remaining
time of the appointment and reset the scheduling time. During the scheduled time, the
machine is shut down or started up under temperature control, and the scheduled time is
always normal, and free from down time. During the scheduled time, it is cleared in case
of power failure.
17