Vortice VORT HR 350 AVEL Betriebsanleitung Seite 23

ENGLISH
User Menu
24 2 24
P1
FILT
1 2 3 4
esc
Prg
/ °C
By-Pass
P2, used to program two periods of operation per day, each with a start time, an end time and a fan speed.
The user can allocate a different profile to each day of the week.
- HA: settings in HA operating mode: available only on appliances with HA module;
- SERV: service (option available only to the installer).
Option PROF (NO UK)
2 25 25
FILT
1 2 3
esc
Prg
/ °C
By-Pass
- ST: start time, profile P1 interval
- END: end time, profile P1 interval
- ST1: start time, profile P2 interval 1
- EN1: end time, profile P2 interval 1
- ST1: start time, profile P2 interval 2
- EN1: end time, profile P2 interval 2
- MON: allocation of profile to Monday: possible values are P1 and P2
- TUE: allocation of profile to Tuesday: possible values are P1 and P2
- WED: allocation of profile to Wednesday: possible values are P1 and P2
- THU: allocation of profile to Thursday: possible values are P1 and P2
- FRI: allocation of profile to Friday: possible values are P1 and P2
- SAT: allocation of profile to Saturday: possible values are P1 and P2
- SUN: allocation of profile to Sunday: possible values are P1 and P2
P2
HA
5 6 7
set
P1 P2 HA
4 5 6 7
set
Before proceeding with the steps indicated below, press
ESC to exit and return to the opening screen. As a rule, the
parameters relative to the various options are selected by
pressing SET (this causes the current value to blink), then
scrolling through the available values with the UP and DOWN
buttons, and pressing SET again to confirm the new value.
The UP and DOWN buttons are also used to scroll through
the different options or parameters. The main user menu can
be viewed by pressing and holding ESC and SET at one and
the same time. The options of the menu are:
- PROF (NO UK only): settings for operation with time
profiles:
P1, used to program one period of operation per day, with
a start time, an end time and a fan speed;
Selecting PROF by pressing SET, the settings for time profiles
are accessed. The parameters are:
- En (Enable): possible values are:
ON: enables operation with profiles (and as noted above,
automatically disables any possibility of operation in HA
mode)
OFF: disables operation with profiles.
If EN ON has been selected, the following parameters are also
enabled:
23