Items Supplied - Vortice VORT HR 350 AVEL Betriebsanleitung

ENGLISH
• The appliance cannot be used to pilot the operation of
water heaters, stoves, etc.; neither must it drain into the
hot water ducts of such appliances.
• The appliance must expel air directly to the outside
through a single dedicated duct.
• The flow of extracted air must be clean (i.e. free of grease,
soot, chemical and corrosive agents and explosive or
flammable mixtures).
• Keep the air intake and outlet ports of the appliance free
of obstructions, to ensure optimum air flow.
• Maximum operating temperature: 45°C.
• Specifications for the power supply must correspond to
the electrical data on ID plate A (Fig. 1).
• The appliance must be installed by a
professionally qualified technician.
• The appliance must be wired to the power
supply by way of a multi-pole isolating switch
with a gap of at least 3 mm between contacts.

Items supplied

The main parts of the appliance are:
• an outer casing made using an expanded polypropylene shell and a
hinged hatch (removable);
• a cross and counter flow heat exchanger, made of polystyrene, featuring
a special geometry designed to guarantee ultra high efficiency in terms of
heat exchange (>85%);
• two energy-saving variable speed brushless motors (2 preset speeds);
• electronic circuits supervising the power input, monitoring and control of
the appliance;
• temperature sensors (bypass and defrost);
• remote controller (wall installation);
• two G3 filters (UK), M5 filters (NOT UK); (option of F5 or F7 filter);
• wall-mounting bracket (optional).
Key to air connections (Fig.2)
A: Fresh air intake from outside
B: Stale air intake from room
C: Clean air outlet inside the room
D: Stale air outlet to outside
16
1 1
A
2 2
A D
B C