Selecting The Input Signal - Sony UP-50 Gebrauchsanweisung

Before Printing (Continued)

Selecting the Input Signal

Selecting the input signal by using the INPUT SELECT button
1
POWER
14
Operation
Before printing, select the input signal (the input connector to which the signal to
be printed is being input) —VIDEO, S-VIDEO, or RGB. Once you have selected
the input signal, this setting remains effective until you select another source.
The following two methods are available to select the input signal:
• Using the INPUT SELECT button
• Using the menu
MEMORY SOURCE/ CAPTURE PRINT
PAGE MEMORY
ALARM PRINT
1
Turn on the video monitor and the printer.
The following appears once the printer is ready to operate.
Video monitor screen
Q1 A 1
2
Press the INPUT SELECT button.
The currently selected input signal appears. The selected signal is lit in green
on the video monitor screen and spelled out in the printer window display.
If you do not perform any operation after you press the INPUT SELECT
button, the currently set item appears for about 3 seconds, after which it
disappears.
INPUT SEL : VIDEO/SV/R
The currently selected input signal
is lit in green and is spelled out.
Printer window display
Q1 A
S
I NPUT S E L
2,3
1 S
:
V I DEO / s v / r
The currently selected input
signal is spelled out.