Sony UP-50 Gebrauchsanweisung Seite 128

Specifications (Continued)
Pin assignment
Signal Remarks
Pin
1 A (Input)
(Input)
2 B
C (Input)
3
4 Reserved (Input)
Capture (Input)
5
6 GND –
(Output)
7 VD output
Light (Output)
8
(Output)
9 Busy
Input: Input the signal at the low level for more
than 100 msec.
VD OUTPUT: The VD of the input signal
currently selected is output.
Light: A high level signal is output when the
printer is capturing the image in memory.
Busy: A high level signal is output when the
printer can capture an image and can print.
A low level signal is output when the printer
a)
cannot capture
cannot print, or when the printer neither can
capture the image or print.
a) When the printer cannot capture the image: When an input
signal already exists in the printer and the user wants to
capture the image in a certain memory location, but
cannot because the image stored in that memory location
is being printed.
Note
When AUTO LIVE of the FUNCTION SETUP
menu is set to OFF, the memory image is
displayed on the screen after the image is captured
in memory. In such a case, whenever you store the
image, press the SOURCE/MEMORY button so
that the source image appears on the video
monitor. Displaying the memory image does not
allow you to capture the image with the correct
timing.
Design and specifications are subject to change
without notice.
128
Others
TTL level
TTL level
TTL level
TTL level
TTL level
–
TTL level
TTL level
TTL level
the image, when the printer