Sony UP-50 Gebrauchsanweisung Seite 11

4
Load the new ink ribbon into the ink ribbon holder.
Spool holding the ink ribbon
Ink ribbon
holder
1 Load the spool holding
the ink ribbon into the
left-hand part of the
holder.
5
Remove any slack from the ink ribbon.
If the ribbon is left slack, it may be damaged when inserted.
6
Insert the ink ribbon cartridge firmly until it clicks.
Confirm that the ink ribbon cartridge is surely inserted.
If the ink ribbon cartridge stops midway, stop inserting it. You may use the
wrong ink ribbon holder. Be sure to use the ink ribbon holder that is designed
for this printer.
When the ink ribbon cartridge cannot be inserted
Turn the power off, then back on gain. Then, insert the ink ribbon cartridge
again.
7
Close the front panel.
Start position mark
2 Fit the other spool into
the right-hand part of the
holder.
Start position marker
Wind the spools alternately
until the start position marker
faces upward.
3 Wind the spools of the ink
ribbon as illustrated until a
start position marker
appears.
Operation
11