teutonia Elegance Bedienungsanleitung Seite 11

Removing the hood cover
Before washing, both hood bars must be removed
from the cover.
Loosen the screw with a screwdriver and remove the
snap. Now pull the cover bar out of the joint and out of
the hood cover. After washing, reassemble in reverse
order.
Make sure that each cover bar is pushed into one of
the stitched guides. The front and back bars must not
be mixed up.
Unfolding the Chassis
Folding the Chassis
Pull up the folding handle 1
(hand grip) up as far as it
will go. The handle lock 2
engages and the arrester
lever 3 automatically
moves over the tube as an
additional safeguard.
WARNING: Ensure
that all the locking
devices are engaged
before use.
Press the two unlocking
buttons on both sides 1, so
that the frame can be fold-
ed together. Release the
arrester lever 2 (by raising
it) and swivel the handle
over to the other side. You
can reduce the storage size
further by folding down the
top of the handle.
Assembling and removing the wheels
Seat cover
The seat cover can be completely removed from the
seat unit in order to be washed. To do this, press the
press studs on the seat unit.
Attention: When fitting the seat cover, please pull the
end of the 5-point harness back through the matching
openings without twisting it.
Height adjustable, collapsible handlebar
Applying the Parking Brake
Before assembling or re-
moving the wheels, press
the locking spring 1. When
assembling the wheels,
make sure that the locking
spring engages properly.
Press and hold the adjust-
ment buttons on both sides
and adjust the height of the
handlebar to the desired
position.
The brake is activated by
pushing down the long
brake lever 1. If it is difficult
to apply the brake, wheel
the stroller back and forth a
few centimetres so that the
brake bars engage properly
in the wheel rim. Make sure
that the brake has locked
securely. You can release
the brake by depressing
the brake lever 2.
11