Error Displays/Messages - Sony CDX-M800 Bedienungsanleitung

The "ST" indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set to the monaural reception mode (page
22).
A programme broadcast in stereo is heard
in monaural.
• The unit is in monaural reception mode.
t Cancel monaural reception mode (page
22).
RDS
The Seek starts after a few seconds of
listening.
The station is non-TP or has weak signal.
t Press (AF) or (TA) repeatedly until "AF
off" or "TA off" appears.
No traffic announcements.
• Activate "TA."
• The station does not broadcast any traffic
announcements despite being TP.
t Tune in another station.
PTY displays "--------."
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the programme
type.
30

Error displays/Messages

Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about 5
seconds, and an alarm sound will be heard.
Blank* 1
No tracks have been recorded on an MD*
t Play an MD with recorded tracks on it.
Error* 1
• A CD is dirty or inserted upside down*
t Clean or insert the CD correctly.
• A CD/MD cannot play because of some
2
problem* .
t Insert another CD/MD.
Failure
The connection of speakers/amplifiers is
incorrect.
t See the installation guide manual of this
model to check the connection.
High Temp
The ambient temperature is more than 50°C.
t Wait until the temperature goes down
below 50°C.
1
NO Disc*
No disc is inserted in the CD/MD unit.
t Insert discs in the CD/MD unit.
NO Magazine
The disc magazine is not inserted in the CD/
MD unit.
t Insert the magazine in the CD/MD unit.
NO Music* 2
A CD which is not a music file is inserted in
the MP3 playable CD unit.
t Insert a music CD in the MP3 playable CD
unit.
Offset
There may be an internal malfunction.
t Check the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
Push Reset
The CD/MD unit cannot be operated because
of some problem.
t Press the RESET button on the unit.
*1 When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2 The disc number of the disc causing the error
appears in the display.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
2 .
2 .