Usb Playback; Error Displays/Messages - Sony CDX-GT828U Bedienungsanleitung

Automatic tuning is not possible.
• The local seek mode is set to "on."
t Set to "Local off" (page 18).
• The broadcast signal is too weak.
t Perform manual tuning.
During FM reception, the "ST" indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set to "Mono on" (page 18).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t Set to "Mono off" (page 18).
RDS
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
t Deactivate TA (page 13).
No traffic announcements.
• Activate TA (page 13).
• The station does not broadcast any traffic
announcements despite being TP.
t Tune in another station.
PTY displays "- - - - - - - -."
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the program type.

USB playback

You cannot play back items via a USB HUB.
This unit cannot recognize USB devices via a USB
HUB.
The USB device takes longer to play back.
The USB device contains files with a complicated tree
structure.
Cannot play back items.
A USB device does not work.
t Reconnect it.
A beep sounds.
During playback, the USB device has been
disconnected.
t Before disconnecting a USB device, make sure to
stop playback first for data protection.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate of
more than 320 kbps.

Error displays/Messages

Blank Disc
Tracks have not been recorded on the MD.
t Play an MD with recorded tracks.
Checking
The unit is confirming the connection of a USB device.
t Wait until confirming the connection is finished.
26
2
Error*
• The disc is dirty or inserted upside down.
t Clean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play because of some problem.
t Insert another disc.
• USB device was not automatically recognized.
t Reconnect it again.
Failure
The connection of speakers/amplifiers is incorrect.
t See the installation guide manual of this model to
check the connection.
Hubs Not Supported
USB HUB is not supported on this unit.
Load
The changer is loading the disc.
t Wait until loading is complete.
Local Seek +/–
The local seek mode is on during automatic tuning.
NO AF
There is no alternative frequency for the current
station.
t Press (SEEK) +/– while the program service name
is flashing. The unit starts searching for another
frequency with the same PI (Program
Identification) data ("PI SEEK" appears).
NO Album Name
An album name is not written in the track.
NO Artist Name
An artist name is not written in the track.
NO Device
(SOURCE) is selected without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
t Be sure to connect a USB device and USB cable.
NO Disc
The disc is not inserted in the CD/MD changer.
t Insert discs in the changer.
NO Disc Name
A disc/album/track name is not written in the track.
NO ID3 Tag*
ID3 tag information is not written in the MP3 file.
NO Magazine
The disc magazine is not inserted in the CD changer.
t Insert the magazine in the changer.
NO Music
The disc/USB device does not contain a music file.
t Insert a music CD in this unit or an MP3 playable
changer.
t Connect the USB device with a music file in it.
NO TP
The unit will continue searching for available TP
stations.
NO Track
1
*
The selected item in the USB device does not contain
an album/track.
NO Track Name
A track name is not written in the track.
3
1
*