Silvercrest STK 650 A2 Bedienungsanleitung Seite 10

4) Remove the brewing system and pull the riser pipe
upwards .
5) Add the desired quantity of tea or teabags to the brewing chamber
NOTE
► Ensure that no tags or bag threads remain in the device .
6) Replace the brewing system in the jug
into the recess on the floor of the jug
inserted with the flattened side towards the handle
7) Close the lid
8) Replace the jug
9) Insert the mains plug into a mains power socket and set the On/Off switch
to the position "I" . The control lamp
The water is now boiled, pressed upwards through the riser pipe
through the brewing chamber
After the water is boiled, the appliance switches to the keep-warm function . The
control lamp
the water cools down, the tea maker boils it again . The control lamp
again during the boiling process .
NOTE
► As the water is fed back through the brewing system when it is re-boiled,
remove the brewing system from the jug
WARNING! RISK OF INJURY!
► The brewing system is very hot! There is a risk of burns! Use oven gloves
when you touch the brewing system .
NOTE
► The longer you keep the drink warm and the more liquid evaporates, the
stronger the drink will become . We therefore recommend drinking the tea
as quickly as possible after it is initially brewed .
■ You can interrupt the boiling process at any time . To do this, set the On/Off
switch
■ Once you remove the jug
CAUTION! PROPERTY DAMAGE!
► Always allow the jug
for another brewing cycle . Otherwise, excessive tension in the glass could
cause the jug
STK 650 A2
1
.
3 on the base
0
4 goes out . Only the On/Off switch
8
to the "0" position . The boiling process stops .
3
3
to cool down before refilling it with cold water
3
to break .
3 . Ensure that the riser pipe
3 . The brewing chamber
5 .
4 and the On/Off switch
3
back into the jug .
8 remains lit up . As soon as
3 after the first brew .
5
from the base the boiling process stops .
q w
with the sieve
0 .
q fits
0 must be
2 .
8 light up .
q
and flows
4 lights up
7
│
GB│CY
8
■