Care And Maintenance; Cleaning And Ordering Spare Parts; Ordering Replacement Parts; Disposal And Recycling - Parkside PDT 40 A1 Betriebsanleitung

Anleitung_LB3_4137762:_
GB/
IE

8. Care and maintenance

Important: Disconnect the equipment from the
compressed air system each time before
starting to carry out maintenance and cleaning
work.
Compliance with the maintenance instructions
given here will ensure that this quality product
has a long service life and offers failure-free
operation.
Before starting work each time, check that the
magazine is securely fastened (Fig. 1/Item E).
Clean the equipment thoroughly immediately
after you have finished the work.
To ensure that your stapler offers lasting perfect
service, it requires regular lubrication. Use the
supplied oil (Fig. 2 / Item M) for this purpose.
There are two possible means of
lubrication:
8.1 By mist oiler
A complete conditioning unit contains a mist
oiler and is fitted to the compressor.
8.2 By hand
If your system has neither a conditioning unit or
a line oiler, 3-5 drops of oil have to be applied to
the compressed air connection each time
before the air tool is started up. If the air tool is
not used for several days, apply 5-10 drops of
oil to the compressed air connection before
switching on.
Store your air tool in a dry room only.
8.3 Other maintenance work
There are no parts inside the equipment which
require additional maintenance.
12
09.02.2011 14:52 Uhr Seite 12
9. Cleaning and ordering spare
parts
Important: Disconnect the equipment from the
compressed air system each time before
starting to carry out maintenance and cleaning
work.
9.1 Cleaning
Keep the trigger catch (Fig. 1/Item H) free of
■
dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it down
with compressed air at low pressure.
We recommend that you clean the
■
equipment immediately after you use it.
Clean the equipment regularly with a damp
■
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the
equipment. Ensure that no water can get
into the interior of the equipment.

9.2 Ordering replacement parts

Please provide the following information on all
orders for spare parts:
Model/type of the equipment
■
Article number of the equipment
■
ID number of the equipment
■
For our latest prices and information please go
to www.isc-gmbh.info

10. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused
or recycled. The equipment and its accessories
are made of various types of material, such as
metal and plastic. Defective components must
be disposed of as special waste. Ask your
dealer or your local council.