Battery; Battery Removal And Assembly - Betamotor RR 350 Bedienungsanleitung

4
WARNING:
Exercise extreme caution if, for any reason, the electrolyte (sulphuric acid) should
come out of the battery. The electrolyte can cause serious burns. In case of contact
with the skin, rinse abundantly with water.
Should the electrolyte come into contact with the eyes, rinse with water for at least
15 minutes and immediately seek medical attention.
Even though the battery is sealed, there is a possibility that explosive gases may
leak out.
Keep sparks and open fl ames away from he battery.
Keep spent batteries out of the reach of children and dispose of them as prescribed
by law.
Do not remove the protections.
When installing the battery, be sure to observe the polarity of the terminals.
GB

BATTERY

Battery is located under the saddle and
requires no maintenance.
Keep the battery terminals clean. If neces-
sary, protect them with a thin fi lm of acid-
free grease.
BATTERY REMOVAL AND
ASSEMBLY
Remove the saddle (page 64).
Release the rubber band.
FIRST disconnect the negative connector
(black) from negative (-) pole and THEN
positive connector (black) from negative
(+) pole.
Remove the battery.
When fi tting the battery, insert it with the
terminals as shown in picture.
FIRST connect the positive connector (red)
from positive (+) pole and then negative
connector (black) from negative (-) pole.
Reattach the rubber band.
56