Front Brake; Check The Level Of The Front Brake Fl Uid; Restoring The Level Of The Front Brake Fl Uid; Bleeding The Front Brake - Betamotor RR 350 Bedienungsanleitung

4
A
2
GB
1
2
1

FRONT BRAKE

CHECK THE LEVEL OF THE FRONT
BRAKE FLUID
Check the level of the brake fl uid through
sight A. The level of the fl uid should never
fall below the mark in the sight.
RESTORING THE LEVEL OF THE
FRONT BRAKE FLUID
To restore the level of the brake fl uid, loosen
the two screws 1, lift cap 2 and add brake
fl uid until its level is 5 mm below the upper
rim of the reservoir.
Use the liquid indicated on page 14 in
the "Recommended lubricants and liquids"
table.
WARNING
The brake fl uid is extremely corrosive. Take
care not to spill it on the paintwork.

BLEEDING THE FRONT BRAKE

To bleed air from the front brake circuit,
proceed as follows:
•Remove the rubber cap 1 from the valve 2.
•Open the sump cap.
•Place one end of a small transparent tube
into the valve 2, and the other end inside
a container.
•Pump with the brake lever 2/3 times and
keep the lever pressed.
•Unscrew the valve and let the oil drain.
•If are still visible in the tube repeat above
operation until obtaining a continuous
outfl ow of oil within no air bubbles.
•Close the valve and release the lever.
NOTE:
during this procedure, continuously top up
the brake pump thank to replace the oil that
is out fl owing.
•Remove the tube.
•Replace the rubber cap.
•Close the oil reservoir cap.
Use the liquid indicated on page 14 in
the "Recommended lubricants and liquids"
table.
44