Troubleshooting - switel BCE15 Bedienungsanleitung

3. Channel selection
S
Each of the units is equipped with a channel selector switch
(OFF, A or B) for the transmission of the radio signals. If
reception is poor or interference occurs in the radio signals,
select the other channel for optimum transmission.
Ensure that both units are set to the same channel.
4. Optimising the sensitivity of voice−activation
S
Set the sensitivity control to a suitable position on the transmitter
unit.
5. Belt clip
S
The transmitter unit and receiver unit are equipped with a belt
clip.

8 Troubleshooting

1. No power
S
The device is switched off. Switch the device to position A or B
using the OFF / A / B switch.
S
Ensure that the batteries have been inserted correctly.
S
Check that the adapter plug is correctly connected to the device.
2. No acoustic signal
S
Volume control on the receiver is set too low. Set a higher
volume.
S
Sensibility control on the transmitter is set too low. Set a higher
sensibility.
S
The devices are out of range. Reduce the distance between the
transmitter and receiver units.
S
Check that both devices are set to the same channel.
3. Interference noise can be heard from the receiver
S
Check that both devices are set to the same channel.
S
Reduce the distance between the transmitter and receiver units.
27