Startup / Operation - BOMANN KS 3261 Bedienungsanleitung

CAUTION CAUTION: : : :
CAUTION CAUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door o Reverse the Reverse the Reverse the door o door o door opening pening pening pening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING: WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE: : : : NOTE
NOTE NOTE
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the cover caps on the top cover. Loosen
the screws underneath and the screws at the
rear. Remove the top cover.
• Dismount the upper door
hinge. Open the appliance
door a little and lift it out of the
lower door hinge.
• Transfer the blind plug
of the appliance door.
Place the appliance
door safely aside.
• Tilt the appliance slightly backwards and block it
screw wrench, Phillips screw-
in this position. Unscrew the
feet. Dismount the lower
door hinge.
• Attach the door hinge at the other appliance side,
after you have unscrewed the hinge pin and used
it from the other hinge side. Turn in the feet ac-
cordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Transfer the upper door hinge at the opposite
side, after you have unscrewed the hinge pin and
used it from the other hinge side.
Put the hinge pin in the hole of
the appliance door and fasten the hinge.
• Replace the appliance cov-
er, which you have removed
at the beginning.
Tight the screws and clip the screw covers on.
• Check if the door is aligned vertically and horizon-
tally optimally so that the smooth opening and
closing of the door is guaranteed.

Startup / Operation

Startup / Operation
Startup / Operation Startup / Operation
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION CAUTION CAUTION CAUTION: : : :
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance Starting the appliance
Starting the appliance Starting the appliance
• Connect the appliance to the power supply.
17