Preparing Hedge Trimmer For Operation; Charging The Battery, Leds; Mounting The Charger On A Wall - Stihl HSA 56 Gebrauchsanleitung

English
or charger are not cleaned correctly, components may no
longer function properly or safety devices may be
rendered inoperative. This can result in serious injuries.
► Clean the hedge trimmer, cutting blades, battery and
charger as described in this instruction manual.
￭ If the hedge trimmer, cutting blades, battery or charger are
not serviced correctly, components may no longer
function properly or safety devices may be rendered
inoperative. This can result in serious or fatal injuries.
► Do not attempt to service or repair the hedge trimmer,
battery or charger.
► If the hedge trimmer, battery or the charger require
servicing or repairs: Contact your STIHL servicing
dealer for assistance.
► Maintain the cutting blades as described in this
instruction manual.
￭ The user can be cut by the sharp cutting edges while
cleaning or servicing the cutting blades. This can result in
personal injury.
► Wear work gloves made of durable material.
5 Preparing Hedge Trimmer for
Operation
5.1

Preparing Hedge Trimmer for Operation

Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– Hedge trimmer, @ 4.6.1.
– Cutting blades, @ 4.6.2.
– Battery, @ 4.6.3.
– Charger, @ 4.6.4.
► Check the battery, @ 9.2.
► Fully charge the battery, @ 6.2.
► Clean the hedge trimmer, @ 14.1.
► Check the controls, @ 9.1.
44
5 Preparing Hedge Trimmer for Operation
► If 3 LEDs flash red while you are checking the controls:
Remove the battery and contact your STIHL servicing
dealer.
Malfunction in hedge trimmer.
► If you cannot carry out this work: Do not use your hedge
trimmer and contact your STIHL servicing dealer.

6 Charging the Battery, LEDs

6.1

Mounting the Charger on a Wall

The charger can be mounted on a wall.
1 2
a
b
a
► Check the following points when mounting the charger on
a wall:
– Suitable fixing materials are used.
– The charger is level.
– The following dimensions are maintained:
– a = at least 100 mm
– b (for AL 101) = 75 mm
– b (for AL 300 and AL 500) = 120 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
3
d
e
e
0458-714-9621-B