Transport And Storage; Procedure In The Event Of Transport; Installation - SOLARWATT 60M style Montageanleitung

tRAnsPORt AnD stORAge

SOLARWATT solar modules are made from high-quality materi-
als and are therefore extremely stable and long-lasting. This
means that, together with the environmentally-friendly,
resource-saving QUICKSTAXX® packaging solution, safe trans-
portation (tested in accordance with ISTA 3E) and easy commis-
sioning are guaranteed. The solar modules should nevertheless
be left in the packaging until installation to help prevent
any damage. The modules should be stored in a dry place and
protected from weather conditions. The packaging (film, tape,
pallet, etc.) should be recycled. Contact the responsible local
waste disposal company.
The fully biodegradable QUICKSTAXX® packaging edges can be
disposed of as household waste or in a suitable compost sys-
tem. Further information is available in the SOLARWATT product
information "Packaging" at www.solarwatt.de.

instAllAtiOn

During installation, please take into account the locally valid
construction regulations, accident prevention regulations, the
relevant, generally accepted rules of technology and safety
regulations for working on roofs and buildings, as well as
electrical installations.
SOLARWATT solar modules must be fixed to suitable substruc-
tures, which are designed for the relevant mechanical wind
and snow loads, as well as the weight of the solar modules. The
instructions from the installation system manufacturer must
also be complied with. No mechanical stresses from the actual
building (e.g., roof truss) must be transferred to the solar
WARning
WARning
The solar module is a glass product and should be handled with appropriate care.
Do not stand on the solar module. Do not allow any objects to fall or place any ob-
jects on the solar module, as it can cause microcracks in the cells. Never hold or
transport the solar module by the junction box or connection cables.
STaTuS: 10/2013 | inSTallaTion inSTrucTionS rev. 6.4 | Subject to change | © 2013 SolarWaTT GmbH

PROceDuRe in the eVent Of tRAnsPORt

DAMAge
You are responsible for checking the goods and packaging
for transport damage immediately on receipt. If any
damage is discovered, note it on the shipping papers
describing each pallet in detail, and take photographs as
documentary evidence. Have the driver countersign these
notes. If more than ten solar modules on one pallet are
damaged, refuse to accept the pallet. Please fill out the
"Transport Damage Complaint Notification" form
(www.solarwatt.de) and return it to SOLARWATT GmbH.
module. Have the structural suitability of the building for the
installation of a solar power system checked by a specialist. The
frame must not be mechanically or chemically processed.
During installation, avoid creating shades with the module
clips or installation system to improve the energy yield.
Comply with the minimum distance of 5 mm between the
solar modules to allow the material to expand without tension.
Do not remove any parts or name- Do not remove any parts or name-
plates from the solar module. Do not plates from the solar module. Do not
install damaged solar modules. install damaged solar modules.
nOte
nOte
11